Heatvape 50W Invader Mini (V2)

Model: HEATVAPE-INVADER-MINI-V2By: Heatvape

Product Description:
Heatvape Invader Mini  50W (V2)

The Heatvape Invader Mini 50w (V2) is the baddest mod on the block.  Drop it, dunk it, step on it or squeeze it in a vice – the Invader Mini will win.  It's frankly unsettling how much abuse the Mini can tolerate and still vape (see the jaw-dropping video below).

But underneath the Invader Mini's ridiculously tough exterior beats the heart of a highly accurate temperature control 18650 mod with a full complement of safety features and user-friendly vv/vw adjustability up to 50 watts.  The Mini has full setting memory on things like wattage, voltage and temperature, and it will only operate in temp control mode when it senses low resistance nickel wire on the atty.  With pure nickel wire on your deck and temperature control mode active you can expect all the benefits of the temperature control revolution that's happening in vaping: unbelievable flavor without dry hits.  The invader will subohm down to 0.1Ω in temp control mode or .16 with regular wire builds.

In the spirit of keeping the Invader sealed and watertight, the unit does not have an adjustable 510 pin or vent holes for the 18650 battery.  Instead, the mini has brilliant substitutions for both.  A removable 510 plate on top of the unit allows you to mount your atomizer and screw it down to make solid contact with the center pin, and if your battery ever vents, the silicone seals around the buttons are designed to give way.

If you still have doubts about this mod's toughness, please watch the MFS video below.  Words really can't do justice to the pounding the Invader Mini can take.  This is the temp control mod for you if you plan to vape in a war zone, or if you're just a fan of fantastic cloudy flavor at a great price.

Specifications

• Output: 1-50w / 1v-9.9v
• Resistance: 0.1-1.0 ohms in temp control mode / 0.16-2.0ohms in regular mode
• Requires 1 high drain 18650 battery
• Temp control up to 600f
• Shock resistant, water resistant, vice resistant
• Wrapped in a rubberized silicone sleeve
• Chip detects whether a regular or temp sensing coil is attached
• Waterproof level: IPX 4
• Dimensions 31.5mm x 39.5mm x 102mm
• Constructed of silicone, zinc alloy, silicone and brass

Using the Invader Mini in Temperature Control Mode: 

Make sure you have nickel or titanium wires on your RDA or in your tank's atomizer.  The invader will not allow you to adjust temperature unless it senses low-resistance coils made of nickel or titanium.

Five press the firing button to lock the mod.

Hold down the + and - buttons for five seconds; the wattage setting on the mod will briefly appear, then the temperature will appear.

Press + and - to adjust the temperature setting (410f is the combustion point of cotton)

Five press the firing button to unlock the mod.

Your temperature is now set.  You can adjust the wattage as you like, and as you fire the temperature control chip will monitor the temperature of the coil and will reduce the applied wattage if the temperature gets close to the temperature you have set.

Note for new vapers: The Heatvape Invader Mini, like nearly all 18650 mods, does not come with an 18650 battery or an 18650 battery charger.  You must buy a battery and charger seperately.  You can find 18650 batteries here and 18650 battery chargers here.
* please refer to each merchant for detailed item description